Page 62 - Y-bearing-units
P. 62

Mounting instructions

        Mounting instructions
        for Y-bearing plummer
        block units
        with a pressed steel housing and grub
        screws
        1  Mount any components that are on the
           shaft between the two Y-bearing units.
        2  Slide the Y-bearings with the locking device
           facing outward onto the shaft – at both
           ends. Install the rubber seating ring on the
           outside diameter of the bearing (optional).
        3  Place the base of each housing on its sup-
           port surface.
        4  Place the shaft and Y-bearings into position
           in each housing base. Then, place the hous-
           ing caps over the bearings († fig. 1) and
           install the attachment bolts or nuts.
        5  Carefully align both Y-bearing units, using
           the shaft. Then, tighten the attachment
           bolts or nuts.
        6  Align the shaft in the bearing arrangement
           axially and – if possible – turn it a few times.
        7  Tighten the grub screws in the inner ring of
           both bearings († fig. 2) to the tightening
           torque indicated in table 1 on page 54.































        60
   57   58   59   60   61   62   63   64   65   66   67