Page 58 - Y-bearing-units
P. 58

Mounting instructions

        Mounting instructions                                             Fig. 1
        for Y-bearing plummer
        block units
        with a composite or cast housing and grub
        screws
        1   Mount any components that are on the
           shaft between the two Y-bearing units.
        2   Slide the Y-bearing plummer (pillow) block
           unit onto the shaft with its locking device
           facing outwards.
        3   Position the Y-bearing unit on the support
           surface. Fit the attachment bolts or nuts
           but do not tighten them.
        4   Mount the other Y-bearing plummer block
           unit on the other end of the shaft, following
           steps 2 and 3.
        5   Carefully align both Y-bearing units, using
           the shaft. Fully tighten the attachment bolts
           or nuts in the housing base.
        6   Align the shaft in the bearing arrangement
           axially and – if possible – turn it a few times.
        7   Tighten the grub screws in the inner rings
           of both units to the tightening torque indi-
           cated in table 1 on page 54 († fig. 1).
        8   If applicable, snap the end cover(s) into
           place.






























        56
   53   54   55   56   57   58   59   60   61   62   63