Page 60 - Y-bearing-units
P. 60

Mounting instructions

        Mounting instructions
        for Y-bearing plummer
        block units
        with a cast housing and an adapter sleeve

        1  Mount any components that are on the
           shaft between the two Y-bearing units.
        2  Determine the position of the adapter
           sleeve on the shaft († fig. 1).
        3  Remove the nut and the locking washer
           from the adapter sleeve († fig. 2).
        4  Wipe the preservative from the bore and
           outside surface of the sleeve.
        5  Expand the adapter sleeve slightly by
           inserting a screwdriver in the slot of the
           sleeve and slide the adapter sleeve into
           position on the shaft († fig. 3).
        6  Slide the Y-bearing plummer block unit up
           onto the adapter sleeve with the large end of
           the tapered bore leading, but do not push it.
        7  Install the locking washer and screw the
           lock nut onto the adapter sleeve until the
           Y-bearing unit is firmly in position on the
           sleeve.
        8  Further tighten the lock nut using one
           of the following:
           –  a hook spanner in the HN series to a
             tightening angle of about 70° († fig. 4)
           –  a TMHN lock nut spanner to a tightening
             angle of about 70°
           –  a torque wrench to the tightening torque
             indicated in table 2 on page 55
           Make sure that while tightening the nut, the
           sleeve does not rotate on the shaft.
        9  Lock the nut in position by bending down a
           tab on the locking washer in one of the slots
           provided around the circumference of the
           nut († fig. 5).
        10  Mount the other Y-bearing plummer block
           unit on the other end of the shaft, following
           steps 2 through 9.
        11  Position the Y-bearing units on their support
           surfaces. Fit the attachment bolts or nuts
           but do not tighten them.
        12  Carefully align both Y-bearing units, using
           the shaft and, if possible, turn it a few times.
           Then tighten the attachment bolts or nuts.
        13  If applicable, snap the end cover(s) into
           place.



        58
   55   56   57   58   59   60   61   62   63   64   65