Page 74 - Y-bearing-units

Mounting instructions

Mounting instructions
for Y-bearing take-up units

with a cast housing and grub screws

1 Mount any components that are on the
shaft between the two Y-bearing units.
2 Slide the Y-bearing take-up units onto both
shaft ends with the locking device facing
outward.
3 Install the shaft and Y-bearing take-up
units into the take-up frames and connect
the adjustment screws via the cast hole in
the units.
4 Align the shaft in the bearing arrangement
axially and – if possible – turn it a few times.
5 Tighten the grub screws on both Y-bearing
take-up units to the tightening torque indi-
cated in table 1 on page 54.
6 If applicable, snap the end cover(s) into
place.

72