Page 46 - Y-bearing-units
P. 46

Design of Y-bearing arrangements

                                    Table 3b
         ISO shaft tolerances for Y-bearings with a standard
         inner ring
         Shaft     Deviations of shaft diameter
         diameter
         d         j5      j6     k5
                   Deviation
         over  incl.  high  low  high  low  high  low
         mm        µm

         10  18    +5  –3  +8  –3  +9  +1
         18  30    +5  –4  +9  –4  +11  +2
         30  50    +6  –5  +11  –5  +13  +2
         50  80    +6  –7  +12  –7  +15  +2





          F or Y-bearings on an adapter sleeve or
        Y-bearings with SKF ConCentra locking, a shaft
        seat machined to h9/IT5 tolerance is adequate.
        The values for h9 ISO tolerances are listed in
        table 3a.
          For Y-bearings with a standard inner ring, the
        same recommendations apply as for standard
        deep groove ball bearings († table 2, page 43).
        The values of these ISO tolerances are listed in
        table 3b.









                                                                        Table 3a
         ISO shaft tolerances for Y-bearings, except for Y-bearings with a standard inner ring
         Shaft     Deviations of shaft diameter
         diameter
         d         h6      h7     h8      h9      h10     h11
                   Deviation
         over  incl.  high  low  high  low  high  low  high  low  high  low  high  low
         mm        µm
         10  18    0  –11  0  –18  0  –27  0  –43  0  –70  0  –110
         18  30    0  –13  0  –21  0  –33  0  –52  0  –84  0  –130
         30  50    0  –16  0  –25  0  –39  0  –62  0  –100  0  –160
         50  80    0  –19  0  –30  0  –46  0  –74  0  –120  0  –190
         80  120   0  –22  0  –35  0  –54  0  –87  0  –140  0  –220





        44
   41   42   43   44   45   46   47   48   49   50   51